[Minnekannabis]

5 gallon fabric pots. We’re using Kronk nutrients and some Recharge. 5×5 AC Infinity tent.

[Minnekannabis]

Try using a hand-held hair dryer.
Lay out your fabric as smooth as possible.
Start on the lowest setting and, from a distance, fan over the creases. Start in one area and smooth your hand over the creases while applying the heat/air velocity. Increase heat/fan speed as necessary. Watch closely!! Let the fabric cool down in position you want (no creases). Move to next area. Or…You could try putting a pillow case over the mylar and ironing out the creases on a cool or warm iron setting. Just be careful of the burn point! Try a small sample area first with either suggestion.
Good luck!
Grandma K

[Minnekannabis]

We’re using 5 gallon fabric pots. When we water, some runoff comes through along the sides. That’s where we’re seeing the discoloration. We figured it was from the nutes.

[Minnekannabis]

I was too anxious and increased the light to 80% before they were ready. We also just tried Recharge on 12/11 and let them get thirsty before watering again tonight with cal-mag. Everything else is dialed in with the controller to perfection. We still might not be giving enough water. We only see about 5-10% runoff. Question: Can we pour the runoff back into the growing pots? We usually just dump it out.

[Minnekannabis]

Think we have our feedings under control but I should have raised the lights and lowered the intensity. Now I think we’re burning the girls. Is it dumb to go back to 50% on the EVO 8? We’re 3 weeks from flipping to flower. Lights are about 20″ from canopy.

[Minnekannabis]

Thank you. We thought we were not giving enough nutes and watering. We’re going to ramp it up a little. Brother  Minnejuana told us to turn the lights up to 70%. Says we’re  babying the babies. Would like to see more growth. Do we get the girls healthy first, before going to the next level? Curren6 readings: Temp: 76.5 Humidity: 67.4 VPD: .098

[Author]

Posts